Rewiring the CNC
Photos as Ian and Andy's move the control board and power supply out from the path of the CNC
Manuals
Andy's_Adventures_in_CNC#Manual
Wiring Diagram
Current problems
Spindle
We think from the inverter manual that
- PD001= Decides whether control is manual or via the board
- PD002= Changes the incoming voltage based on the speed of the board
- PD070= Analoge Volage input - should be 1 (0-5V) as we've confirmed this is what the board is outputting
Results:
PD001=0 PD002=0 Spindle turns on/ off from controller but speed control dial doesn't work
PD001=0 PD002=1
- Without pressing green button M commands do nothing
- Error when pressing green button and issuing M commend
- Interestingly M3 (full on) doesn't work
PD001=1 PD002=1 Spindle should (?) be controlled by board but no M commands work
Photos
Current setup as of Jan 2021
Board
Back
Jumpers
CNC estop box internals
Spindle Inverter Speed control
This wire comes from the estop box to the spindle inverter front panel and delivered a 0-5V range
Inverter power
Incoming power and
Prior to changes
